Lotus 4" Round 11W Economy Superthin

Lotus 4" Round 11W Economy Superthin

  • For Insulated & Dropped Ceilings and Soffits.

  • Dimmable
  • cULus Listed and Energy Star Certified
  • Type IC Rated – Approved for Direct Contact with Insulation
  • Air-Tight, Damp Location, Insulated and Non Insulated Ceilings
  • Pot Light Housing is NOT Required even for Insulated Ceilings
  • Warranty: 5 Year
  • Rated Life: 36 000 Hour 
Add To Cart


We recommend LED/CFL dimmers that have a low range adjustment dial. After all fixtures are connected to the dimmer adjust the dial to the lowest position before the lights start to flicker of shut down. This setting depends on the local voltage and number of fixtures per dimmer.
For a typical LED dimmer rated for 150W LED load the maximum number of fixtures per dimmer is 13.

Connecting the Driver

Open the cover of the junction box. Push and remove one of the half-inch knockouts on the side plate. Install standard L16 cable connector. Use double connector for daisy chaining multiple drivers. Insert line voltage feed into the cable connector and splice same colour wires using wire nuts. Close the cover. Connect the driver to the light fixture – the arrows on the male and female parts of the connector between the driver and the fixture should match. Tighten the connector by hand. Do not attach the junction box to anything so you can pull it through the ceiling opening in case you need to service the driver in future.

Locating the Driver

Locate next to the fixture – run line voltage wiring to first junction box and “daisy chain” to the junction boxes of the other fixtures.

Or install all drivers at one location and use low voltage extension cables to the fixtures. Use only extensions provided by the manufacturer. Available jumper cables are 10 feet (3m) – cat # EXC10. Cables are linkable.

Maximum run should not exceed 40 feet (12m).

Light Color

Warm White 3000K is yellowish, similar to halogen and incandescent light. Creates soft, calming feeling. We recommend the Warm White for bedrooms, living rooms and kitchens with warm coloured countertops and cabinets.

Neutral White 4100K is whiter, colder and more energizing light. Using this colour will make the room look white, modern and brighter. We recommend the Neutral White for bathrooms, offices and work areas, garages, kitchens with white or dark countertops and cabinets.



  • Driver Input Voltage: 120V AC (Dimmable)
  • Power factor: > 0.98
  • Energy Used: 11W
  • Halogen equivalent: 65W
  • Beam Angle: 110°
  • Light colour options: Warm White 3000K and Neutral White 4100K
  • Light output: Warm White 700 lm, Neutral White 730 lm
  • CRI: 80 for the 3000K and 82 for the 4100K
  • Ambient Operating Temperature: -40°F (-40°C) to +104°F (+40°C)
  • Compliance: cULus Listed, certified to CSA STD. C22.2 No. 250.0
  • Rated: Type IC (Direct Contact with Insulation), Energy Star, Air-Tight


  • ID 4″; OD 4 7/8″; Thickness 1/2″
  • Cut out: 4″ to 4 1/4″
  • Junction Box Dimensions (with driver inside): 3 3/4″ x 3 3/8″ x 1 1/2″

Suitable for damp locations and soffit installations.



Driver Installation


Lotus LED Lights ship within two days.